Clean-Up After Installation - Kohler Puebla K-1592 Manual Del Usuario

CLEAN-UP AFTER INSTALLATION

When cleaning up after installation, use warm water and
an approved liquid cleanser to clean the surface.
CAUTION: Risk of product damage. Do not use
abrasive cleansers.
Stubborn stains, paint, or tar can be removed with
turpentine or paint thinner.
CAUTION: Risk of product damage. Do not
allow cleaners containing petroleum distillates to
remain in contact with fiberglass reinforced plastic
surfaces for any length of time.
Plaster can be removed by scraping with a wood edge. Do
not use metal scrapers, wire brushes, or other metal tools.
Use warm water and an approved liquid cleanser to
provide mild abrasive action to remove residual plaster.
6. IMPORTANT CONSUMER INFORMATION
CONSUMER RESPONSIBILITIES
Wipe out your gel coat fixture with a soft cloth after each
use to prevent a build-up of soap and scum. If the surface
gets excessively dirty you can use a general purpose
cleaner such as: Scrub Free® Soap Scum Remover, 409®
All Purpose, Mr. Clean Lemon Fresh, Glass Plus®, or
Fantastik®. You can also use an automotive-type
polishing compound, followed by an application of
good-quality paste wax.
Do not use abrasive cleansers or solvents on gel coat
products.
Avoid cleaning products that contain the following
chemicals, as they will damage the finish of your gel coat
fixture: acetone, ethyl alcohol, amyl or ethyl acetate,
sodium hypochlorite, toluene, or phenol.
Extreme heat such as that generated by cigarettes or
portable heaters can damage gel coat surfaces; do not
use such items near your fixture.
Kohler Co., Kohler, WI U.S.A.
7
B
1010415-2-