Unpacking The Device; Power Sources - LEXIBOOK RCD102 Serie Manual De Instrucciones

17. The product may be mounted to a wall only if recommended by the
manufacturer.
18. Upon completion of any service or repairs to this product, ask the service
technician to perform safety checks.
When unpacking, ensure that the following elements are included:
1 x Boombox CD Player
1 x AC cable
1 x instruction manual
WARNING: All packaging materials, such as tape, plastic sheets, wire ties
and tags are not part of this product and should be discarded.
The Radio CD Player operates on AC 230V – 50Hz or with 6 x 1.5V
size batteries (not included).
AC operation
1. Check that the unit is switched off.
2. Insert the small end of the AC cord into the AC socket at the back of the
unit.
3. Plug the other end of the AC cord into any convenient AC 230V – 50Hz
mains power socket.
Battery installation
1. To install the batteries, open the battery
compartment located at the back of the unit by
pressing in on the tabs, then lifting it off.
2. Insert 6 x 1.5V
observing the polarity indicated in the compartment,
and as per the diagram shown opposite.
3. Close the battery compartment.
Note: The AC power cord must be disconnected from the AC socket on the
rear of the unit in order for the product to operate on battery power.
Non-rechargeable batteries are not to be recharged. Rechargeable
batteries are to be removed from the product before being charged.
Rechargeable batteries are only to be charged under adult supervision.
Different types of batteries or new and used batteries are not to be mixed.
Only batteries of the same or equivalent type as recommended are to
be used. Batteries are to be inserted with the correct polarity. Exhausted
batteries are to be removed from the product. The supply terminals are not
to be short circuited. Do not throw batteries into a fire. Remove the batteries
if you are not going to use the game for a long period of time.

UNPACKING THE DEVICE

POWER SOURCES

/C size batteries (not included)
13 13
/C