To Install The Intermediate Slats; To Install The Upper Slats - Daikin EKLN140A1 Manual De Instalación

4 Unit installation
2 Install the 2 lower slats.
4.6.2

To install the intermediate slats

1 Tilt the intermediate slats into the vertical supports.
2 Position 4 intermediate slats on each side.
3 Bend the mounting lips 90° in respect of the slats.
INFORMATION
The lips MUST be connected to the vertical supports.
4 Hold the lip and vertical support firmly by hand to make sure
that the holes align with one another.
5 Fix the lip with M5 Torx screws (accessory A) and washers
(accessory B) inserted from outside.
INFORMATION
Tighten them hand-tight (tightening torque <5N∙m).
4.6.3

To install the upper slats

1 Tilt the upper slats into the vertical supports.
2 Place the slat at the top over the vertical supports.
3 Slide the slat into the notches below in the vertical supports.
Installation manual
8
4 Fix the 8 guide pins (accessory M) with the M5 Torx screws
(accessory A). A washer is NOT needed in this case.
5 Fit a 12×7 spacer bush (accessory O) over the upper guide pins
(4×).
6 Fit the 4 additional M5 Torx screws (accessory A) and washers
(accessory B).
INFORMATION
Tighten them hand-tight (tightening torque <5N∙m).
a Guide pins (accessory M) with M5 Torx screw (acessory
A)
b Spacer bush (accessory O)
c Additional M5 Torx screw (accessory A)
7 Fit the self-adhesive D-rubber (accessory P) to all edges of the
vertical support, base frame, and upper slats.
8 Make sure the rubber is adhered flush with the outside of the
sheet metal plate edges.
INFORMATION
Dry and degrease the sheet metal plate with a neutral
cleaning agent to ensure that the D-rubber adheres
properly. Cut the rubber to length with scissors.
a
a Self-adhesive D-rubber (accessory P)
b
a
c
EKLN140A1
Low sound enclosure
4P650154-1A – 2021.04