Technical Data - CEMO SW 20-P Manual Del Usuario

Spreading table
Spread volume in g/m
2
Spread width: 3 m
Travel speed: 5 km/hours
Aperture position
½
¾
1
Note: The spread volume listed in g/m² has been
measured at a spread width of 3 m and a travel speed of
approx. 5 km/hours (3.1 mph). The values listed are guide
values; actual values may differ considerably depending
on the characteristics of the material spread. The area
of spreading varies with the travel speed, and the values
should be recalculated accordingly.
Recommendation: To determine the exact spread
volume, we recommend carrying out a calibration spread,
e.g. spreading along a measured path.
Gritting material
The SW 20-P spreaders are particularly suitable for
spreading salt, sand and gravel on paths, roads, school-
yards, parking areas, etc. under snow and ice conditions.
• Granular material in general, granulated and powdered
fertiliser, sand, salt, gravel, etc.
The equipment must be carefully cleaned when changing
the product. Grain size up to 5 mm.
c
Grit (3.5) Salt
12 6
35 13
55 20
Spreading quantity is set using
a lever c which regulates the
amount of material spread.
Clean the equipment with a water jet after use. After
cleaning, dry the sliding shutter and guides thoroughly
and lubricate
them well. The gear assembly does not require servicing
since it is of „LONG LIFE" type.

Technical data

Hopper Weight
content
Height Width
SW 20-P
l kg/lbs kg/lbs cm/in
19 23/50 9/19.5 70/27.6 50/19.7 43/17
Dimensions Spread width
Length Grit/sand/salt
cm/in cm/in m
1 - 3
GB
ft
3
/ - 9
1
3
3