Sinbo SFH 3365 Manual De Instrucciones página 8

20) If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
21) If the product has been exposed to temperatures below 0ºC for some time, it should
be kept room temperature for at least 2 hours before turning it on.
22) Young children should be supervised to ensure that they do not play with the appliance.
23) This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
ASSEMBLE INSTRUCTION AND USING AREA
Before Using:
A. The heater should be put on a smooth solid tabletop or ground, then insert the plug.
(Warning: The requirement of the socket and cable: AC220-224V, 50Hz,10A and earthing
cable necessary.
B. Don't insert the cable before installing the wheels
Install the wheels
Attach the wheels to the bottom of the convector, make sure that the bolt holes are
properly aligned, then tighten the screws (supplied).
MOUNTING TO THE WALL
• Attach the large bracket to the wall, using the available bolts and nuts (supplied).
• Place the heater, leaving the distance between the base device and the floor for at least
50 cm, and make sure that the distance between the upholstery and curtains is at least
1 m. Attach the rubber stops to the back of the device.
Place a large staple to the rear of the notches on the side of the device. Wear protective
top small brackets and screw them to the larger ones. It is necessary to secure the
convector on the wall.
PARTS DESCRIPTION
1. Power switch knob, 2. Thermostat knob, 3. Control panel, 4. Real panel, 5. Wall
mounted bracket, 6. Rubber post, 7. Support base, 8. Wheel
SWITCHING ON THE DEVICE
• Plug it into a suitable outlet, set the temperature controller at the highest level (i.e.,
turn the knob clockwise until it stops), High position.
TEMPERATURE CONTROL
• When using this device you feel that the room temperature is too high, you can reduce
it as follows: turn the temperature controller anti-clockwise from the maximum position.
After that, electric convector would work intermittently.
- 7 -