Remote Controller - Hitachi RAK-50PXA Manual Del Usuario

NAMES AND FUNCTIONS OF REMOTE

REMOTE CONTROLLER

This controls the operation of the indoor unit. The range of control is about 7 meters. If indoor lighting is
controlled electronically, the range of control
be controlled from the remote controller.
Handle the remote controller with care. Dropping it or getting it wet may compromise its signal transmission
capability.
After new batteries are inserted into the remote controller, the unit will initially require approximately 10
seconds to respond to commands and operate.
When remote controller is not in use for about 3 minutes during OFF condition, indicated by
display, the LCD will turn off.
During clock setting, the LCD will turn off about 10 minutes later if the remote controller is not in use.
When pressing any button, the LCD will turn on.
The LCD will not turn off during TIMER setting.
Signal Transmitting/Receiving
Window
Point this window towards the
indoor unit when controlling it.
Sensor
A temperature sensor inside the
remote controller senses ambient
temperature around the remote-
controller.
Display
This indicates the room temperature
selected, current time, timer status,
function and airflow rate selected.
ROOM TEMPERATURE setting Buttons
Press these buttons to set the room
temperature.
Press the [ ] button to raise the room
temperature.
Press the [ ] button to lower the room
temperature.
Keep pressing and the value will change
more quickly.
CONTROLLER
ler may be shorter.
– 9 –
Transmission sign
The transmission sign lights up
when a signal is sent.
START/STOP button
Press this button to start
operation. Press it again to stop
operation.
FAN SPEED selector Button
This determines the fan speed.
Every time you press this button,
the airflow rate will ch ange from
(AUTO) (HIG H)
(MED) (LOW)
(SILENT) (This button allows
selection of optimal or preferred
fan speed for each operation mode).
ECO Button
Use this button to set the ECO
mode.( p.19 )
on the