General Usage Instructions - DeWalt DWMIIIFS Instrucciones De Instalación

GENERAL USAGE INSTRUCTIONS

1. Be sure foot is flush to flooring.
2. Strike both sides of foot to set flooring
3. Actuate tool after flooring is set.
4. Roll tool to next fastener position.
CORRECT FASTENER PLACEMENT/ DEPTH
When tool is properly shimmed and with correct air pressure, fasteners should be set into flooring tongue.
(see example below)
Important: always test on a scrap piece of flooring.
• Air pressure too low.
• Fastener above tongue.
• Increase air pressure.
Floor
Fastener
DO NOT STRIKE PRE-FINISHED FLOORING!!
• Air pressure too high.
• Fastener buried.
• Lower air pressure.
Sub-floor
Use the window to verify that the
foot is flush against flooring.
• Correct air pressure.
• Fastener just below surface.