Installation Steps - Air Live WL-5460AP v2 Guía De Instalación Rápida

Installation Steps

1. Please install your network cards first before the AP device
2. Screw-in the antenna (clockwise) into the Antenna connector
3. Connect the power and LAN cable to the back
4. Use your wireless card to do a site survey, the default SSID is
airlive and Channel is 13
5. If you need to change AP's configuration, please follow the
procedure below:
■ The AP's default IP address is 192.168.100.252. Please
make sure your computer IP is in the same subnet as the AP
(i.e. 192.168.100.x)
■ Open the web browser and enter http://192.168.100.252/.
Wireless Mode Setup
This page include all primary and major parameters for the wireless mode
setting. Any parameter change will cause the device to reboot for the new
setting to take effect.
Wireless Modes: AP, Client, Bridge, WDS Repeater,
Universal Repeater, WISP(Client router), and
WISP+Universal Repeater
The default mode is set to AP. You can change it to another mode.
Network Type: When in Client mode, you can select between Ad-Hoc or
Infrastructure.
Wireless Access Point
WL5460AP v2
English
5
5