Pure H2O H2O-F12 Manual De Instrucciones

Filter Replacement Instructions
Replacement Filter for Watts Pure
H20 Series Under Counter Push
Button Drinking Water Systems.
Applicable Filter Models: H2O-F12, H2O-F13,
H2O-F14, H2O-F15, H2O-F16, H2O-F17
Parts Included: One Replacement Filter
Operating Specifications: Please refer to the information
on the relevant filter box / filter label
! CAUTION
Other filters may look the same, but only use certified PureH2O
manufactured replacement cartridges in systems in order to ensure
proper reduction of water contaminants
WARNING
!
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system.
Where Used:
Model number
/ Watts Part
Number Description
H2O-F12 / Carbon Block Filter
88005217
H2O-F13 / Lead/Volatile organic
88005235 Compound Filter
H2O-F14 / Sediment Filter
88005215
H2O-F15 / Ultra-Filtration
88005447
H2O-F16 / Reverse Osmosis
88005218 Membrane Filter
H2O-F17 / Granular Activated
88005219 Carbon Filter
Component tested & certified by WQA for NSF/
ANSI 372 standard for 'Lead Free' compliance.
COMPONENT
Filter
Change
Used in System Time Frame
H2O-DWCB200 6 months
H2O-DWUF300
H2O-DWRO300
H2O-DWGC100 6 months
H2O-DWGC101
H2O-DWCB200
H2O-DWUF300
H2O-DWCB200 6 months
H2O-DWUF300
H2O-DWRO300
H2O-DWUF300 12 months
H2O-DWRO300 2-5 Years
H2O-DWGC100 12 Months
H2O-DWGC101
IMPORTANT
If you are unsure about installing your WATTS water filter, contact a
WATTS representative or consult a professional plumber.
Replacement instructions:
Step 1: Place a towel under the filter
module to catch any excess water
that may drip out from the filters
during the changeover.
Step 2: To remove a filter cartridge:
Push and hold the button on the
valve head above the filter. Twist
filter counter-clockwise for about
45 degree while pulling downward
(from the head) Release button and
discard old filter.
Step 3: To install a filter cartridge:
Remove the seal cap and insert the
cartridge into the filter head, push
upward and twist the filter clock-
wise for about 45 degree until you
hear an audible "click" (the button
does not need to be pressed to
install new filters).
Step 4: Turn faucet handle to the
open position to start the flow
of water through the unit. Run 3
gallons of water through the unit in
order to flush out the normal black
carbon fines (it will "sputter" until
the air is purged out) from the unit.
A container with a known volume
can be filled to determine how
much water has flushed through
the system. Initially, the water
may appear cloudy which is due
to tiny air bubbles and it will clear
up shortly. Close the faucet when
finished.
Step 5: Check for leaks. If you have
any leaks, shut off the water supply
to your system, tighten any fittings /
housings then turn the water supply
back on. Check frequently over the
next 24 hours to ensure no leaks are
present. If you have any questions,
please call our retail customer
service at (888)321-0500.
NOTICE
Tubing not shown in above pictures. Do not remove the tubing
while changing the filter
Step 2
Step 3-1
Step 3-2
Step 3-3