EDM Product 31844 Manual De Instrucciones página 6

EN
Installations
1. Prepare lamp, accessories and tools well firstly.
2. Use Allen wrench to loosen the light panel and adjust it to the demanded lighting angle (see
picture 1 ), then fix the screw tightly (see picture 2).
3. Rotating the screw to loosen the bracket (see picture 3), adjust it to the appropriate angle
and then fix the screw tightly (see picture 4).
EN
Installation A: Wall Mounted
Please use the measure card to drill 2 holes of Ø8mm with a spacing of 198mm, then fix the
lamp onto the wall with expansion plugs and screws.
* The recommended mounting height is 2-4m
Measure card
Installation B : Put flat surface directly
Push aside the stand bracket and put it on a flat surface
Instruction manual
Ref. 31844
Instruction manual
Ref. 31844
EN
Installation C: Hang on the wall
1. Please drill 2 holes of Ø8mm on the wall with a spacing of 140.5mm. (see picture 1).
2. Fix the expansion plugs and screws into the holes with a spare space(do not lock to the
bottom). (See picture ).
3. Push aside the stand bracket, align the hanging holes to the screws and hang the lamp on
the wall. (see picture )
* The recommended hanging height is less than 2Mtrs.
Installation D: Pole Mounted (Optional)
(Requirements for pole mounted installation: 2pcs U-shaped brackets (not included in the
packing))
U-shaped bracket
Please use 2pcs U-shaped bracket to mount the lamp onto the pole.
This installation is workable for both round light pole (diameter Ø40~60mm) and square light
pole (diameter Ø30~40mm).
EN
Applications
· It can be used as wall light, flood light, security light, camping light, portable light, work light,
hanging light, garden light, pole light etc..
· You can easily install it for garden, courtyard, parking lot, square, villa, garage, pathway,
entrance etc.
Notice
1. This is a solar powered lamp, please install it in a location where can get enough sunshine.
2. Please note the lighting time depends on sunshine duration & weather & work mode.
3. The lamp will light up automatically at dusk in Sensor Mode.
4. Built-in intelligent IC is with over-charge, over-discharge and over-voltage protection.
5. The lamp is equipped with an internal battery pack, which is replaceable.lf any need, please
contact seller for correct new battery pack.
6. If the battery is taken out and put back in or replaced with new ones, please toward the
solar panel to sunshine or a strong light to activate the lamp.
7. Non-professionals please do not disassemble the lamp.
8. Please do not dispose the battery with household garbage to avoid explosion.
Instruction manual
Ref. 31844
Instruction manual
Ref. 31844