Klein Tools VDV Scout Pro 3 Manual De Instrucciones página 11

COAX CABLE PROPERLY WIRED:
Pass
ID
1. Loosen screw ion battery cover with No. 2 Phillips screwdriver.
2. Remove the battery door.
3. Disconnect the battery cable and recycle the exhausted battery.
4. Install a fresh 9-volt alkaline battery.
5. Battery should be installed with the connection towards
the bottom of the tester, as shown.
6. Replace battery door and secure with a screw,
taking care not to over-tighten.
Turn the instrument off and disconnect any cables. Clean the instrument using a damp cloth.
Do not use abrasive cleaners or solvents.
Remove the batteries when the instrument is not in use for a prolonged period of time. Do not
expose to high temperatures or humidity. After a period of storage in extreme conditions exceed-
ing the limits mentioned in the Specifications section, allow the instrument to return to normal
operating conditions before using it.
Do not place the equipment and its accessories into a domestic rubbish bin. Items must
be properly disposed of in accordance with local regulations. Please see www.epa.gov or
www.erecycle.org for additional information.
TEST + MAP™ ID REMOTES (VDV501-2## SERIES)
Use for cable location identification mapping and continuity testing.
Remotes display on tester as Remote ID Nos. 1-12.
RJ45 port
WIRE MAP AND DISPLAY EXAMPLES
COAX CABLE WITH AN OPEN:
Open
BATTERY REPLACEMENT
WARRANTY
www.kleintools.com/warranty
CLEANING
STORAGE
DISPOSAL/RECYCLING
UPGRADE/REPLACEMENT REMOTES
F-connector port
CUSTOMER SERVICE
KLEIN TOOLS, INC.
450 Bond Street, Lincolnshire, IL 60069 1-800-553-4676
www.kleintools.com
NOTE: An open
fault will also
occur when
no remote is
connected to the
satellite end of a
video/coax cable.
2–6
COAX CABLE WITH A SHORT:
Short
REMOTE ID NO. PART NO.
1 VDV501-211
2 VDV501-212
3 VDV501-213
4 VDV501-214
5 VDV501-215
6 VDV501-216
7 VDV501-217
8 VDV501-218
9 VDV501-219
10 VDV501-220
11 VDV501-221
12 VDV501-222
2–6 VDV770-850
7–12 VDV770-851
11