GE GTH21 Manual Del Propietário página 14

ICEMAKER INSTALLATION INSTRUCTIONS
5
INSTALL THE ICEMAKER FILL CUP
Install the icemaker fill cup (side-mounted) into the
icemaker as shown.
6 PLUG IN THE ICEMAKER
Holding the icemaker in place, insert the icemaker
power cord plug into the socket on the back wall,
making sure the prongs and holes are matched.
Press the plug firmly into the socket. Lock the plug
in place by clipping the restraints onto each side of
the plug. Make sure the restraints click into place.
Installation Instructions
Icemaker
fill cup
14
MOUNT THE ICEMAKER
7
• Lift the icemaker so the fill tube extension fits in
the fill cup opening. Hang the icemaker on the
two screws.
Make sure:
• The power cord is still firmly in the socket.
• The fill tube extension extends into the
fill cup opening at the back of the icemaker.
(Check the rear of the refrigerator to make sure
the fill tube has not been pushed out of the back
of the refrigerator).
• The icemaker mounting screws are located in the
uppermost position of the mounting slots.
THEN SECURELY TIGHTEN THE ICEMAKER
MOUNTING SCREWS.
8
INSTALL THE ICE BUCKET
Place the ice bucket under the icemaker.
Make sure the icemaker power switch is in the
O (off) position.
Ice bucket
REMOVE THE COVER
9
Use a Phillips head screwdriver to remove the
compressor compartment access cover. This
requires removing six screws which attach the
cover to the back of the refrigerator case.
Be sure to save the screws as the access cover must
be reinstalled later to ensure your refrigerator will
function properly.
(CONT.)
Fill tube
extension
Fill cup
opening