Descargar Imprimir esta página

ProSelect PSWFUCRC100 Manual Del Usuario página 2

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTRUCTIONS
1.
Turn off water supply.
2.
Remove the old cartridge from the
manifold by rotating it to the left
until it unlocks. Pull cartridge down
and discard.
3.
Remove new cartridge from
packaging. Ensure all connection
points are aligned before attaching
new cartridge to the manifold. Push
in the cartridge and turn to the right
until it locks into place.
4.
Ensure all connections are aligned
and cartridge is securely attached
prior to turning on water supply.
5.
Turn on the water supply to
pressurize the system and
ensure there are no leaks.
6.
Turn faucet on and run water through the cartridge at full force for at least
10 minutes. This action will purge the system of air and carbon fines,
ensuring maximum filter life and an effective water filtration system.
System Tested and Certified by IAPMO R&T Lab
and IAPMO R&T against NSF/ANSI Standards
42, 53 and conforms to NSF Protocol in model
PSWFUC100 as verified and substantiated by
test data. Please refer to Performance Data
Sheet for specific contaminant reductions.
Systems certified for cyst reduction
may be used on disinfected waters
that may contain filterable cysts.
Rated Capacity: 4750 gal (17,968 L)
For use with municipally treated
water only. Do not use with water
that is microbiologically unsafe or of
unknown water quality without adequate
disinfection before or after the system.
Use of parts from other manufacturers
may result in loss of contaminant
reduction performance, system
damage or failure. Use of parts from
other manufacturers will also void
your warranty. PROSELECT is not
liable for consequential or incidental
damages due to improper installation.
PROSELECTPRODUCTS.COM
©2020 Ferguson Enterprises, LLC 0220 1513154

Publicidad

loading