Gas Requirements; Safe Grilling Environment - Teka TBBQ 4100 G SS Manual Del Usuario

GAS REQUIREMENTS

CAUTION: It is important to inspect the full length of the gas hose. If it is evident there is excessive abrasion or wear,
or the hose is cut, the hose must be replaced before using this appliance.
NEVER use an unregulated gas supply.
Refer to the following table for supported gas type:
Cat
Nozzle Size
Country code
Gas Type and Pressure
Nominal heat input
Total Heat Input

SAFE GRILLING ENVIRONMENT

This gas appliance is designed and certified for outdoor use only. Do not operate the grill inside a building, garage,
recreation vehicle, screened porch or any enclosed area. Keep the grill away from windy areas but keep the grill in a
well-ventilated area. Do not obstruct the flow of the combustion and ventilation air around the grill.
• CLEARANCE TO COMBUSTIBLE CONSTRUCTION
A minimum clearance of 1 m from the sides of the grill and a minimum clearance of 1 m from the back of the grill
to adjacent vertical combustible constructions must be maintained. We strongly recommend a 1 m clearance of the
grill to any combustible constructions.
• CLEARANCE TO NON-COMBUSTIBLE CONSTRUCTION
A minimum clearance of 1 m from the back of the grill above the cooking surface to noncombustible constructions
is required to allow the grill hood to open completely. A minimum of 1 m clearance to the sides of the grill above
the cooking surface to noncombustible constructions is recommended. The grill can be installed directly next to
noncombustible construction below the cooking surface.
Warning: Do not place the grill under overhead, unprotected combustible surfaces.
 I3+(28-30/37)
Main Burner: 0.88mm
Side Burner: 0.92mm
BE, CH, CY, CZ, ES, FR,
GB, GR, IE, IT, LT, LU, LV,
PT, SK and SI.
G30 Butane at 28-
30mbar and G31
Propane at 37mbar
I3B/P(30)

Main Burner: 0.88mm
Side Burner: 0.92mm
AL, CY, DK, EE, FR, FI,
HU, IT, LT, NL, NO, SE,
SI, SK, RO, HR, TR, BG,
IS, LU, MT and CZ.
G30 Butane and G31
Propane at 30mbar
Qn= 3.22 kW
∑Qn=16.39 (1193g/h) kW
EN-20
I3B/P(37)

Main Burner: 0.85mm
Side Burner: 0.89mm
PL
G30 Butane and G31
Propane at 37mbar
I3B/P(50)

Main Burner: 0.76mm
Side Burner: 0.81mm
AT, CH, CZ, DE and SK
G30 Butane and G31
Propane at 50mbar