Changing Your Login Name And Password; Verifying External Connectivity; Resetting The Device To Factory Defaults - Juniper Networks NETSCREEN-5GT Guía De Usuario

Chapter 2 Configuring the Device
C Y
HANGING
Because all NetScreen products use the same default login name and password
(netscreen), it is highly advisable to change your login name and password immediately.
In a Telnet or Console session, enter the following CLI commands:
set admin name name_str
set admin password pswd_str
save
For information on creating different levels of administrators, see the "Administration"
chapter in Volume 3 of the NetScreen Concepts & Examples ScreenOS Reference Guide.
V E
ERIFYING XTERNAL
To verify that workstations in your network can access resources on the Internet, start a
Web browser from any workstation in the network and enter the following URL:
www.netscreen.com.
R
ESETTING THE
If you lose the admin password, you can reset the NetScreen device to its default settings.
This destroys any existing configurations, but restores access to the device.
Warning: Resetting the device deletes all existing configuration settings and renders
existing firewall and VPN service inoperative.
You can restore the device to its default settings in one of the following ways:
• Using a Console connection. For further information, see the "Administration"
chapter in Volume 3 of the NetScreen Concepts & Examples ScreenOS Reference
Guide.
• Using the reset pinhole on the rear panel of the device, as described in the next
section.
14
L N
OUR OGIN
C
ONNECTIVITY
D F
EVICE TO
P
AME AND ASSWORD
D
ACTORY EFAULTS
User's Guide