Desa RM100LP Manual Del Propietário página 10

SERVICE PROCEDURES
Continued
IGNITOR
1. Remove motor, motor mount and fan guard
(see Motor, page 8, steps 1 through 6) .
2. Remove orange ignitor wire from ignitor.
3. Remove ignitor mounting screw from rear
head using nut-driver or standard screwdriver
(see Figure 11).
4. Remove ignitor from rear head.
5. Install new ignitor. Attach ignitor to rear head
with ignitor mounting screw.
6. Attach ignitor wire.
7. Check gap between ignitor electrode and
nozzle to .13"/.15" (3.3/3.8 mm) (see Fig-
ure 12).
8. Test for spark.
WARNING: Make sure heater
is disconnected from propane
supply. Heater could ignite caus-
ing severe burns.
Plug into extension cord and watch for spark
between ignitor electrode and nozzle.
9. Place motor, motor mount and fan guard into
rear of heater shell (see Motor, page 8, steps
14 through 18).
10
Ignitor
Mounting
Screw
Figure 11 - Removing Ignitor Mounting
www.desatech.com
Ignitor
Screw and Ignitor
Rear
Head
111710-01B