Installation; Preparing For Installation - Glacier bay 7043-207SS Guía De Uso Y Cuidado

Installation

1

Preparing for installation

 Remove the old sink strainer and thoroughly clean off old putty
from around the sink opening (top and bottom).
 Holding the metal flange, unscrew the long white threaded piece
from under the flange and let it slide down the cable.
 Holding the black cable connected to the metal flange and push
button, unscrew the metal push button assembly and set aside.
 Make sure the long white thread piece in the step above does not
get lost or broken.
NOTE: If not already supplied in sink or counter top, suggested hole
diameter for push button mounted assembly is 1 inch.
2
Installing the basket strainer
 Remove the strainer basket from the strainer cup and set aside.
 Separate the strainer cup from the strainer body by unscrewing
the bolt in the center of the cup. A screwdriver may need to be
used to loosen up the bolt if assembled too tight.
 Apply a bead of plumer's putty around the underside of the
strainer cup flange.
 Position the strainer cup in the sink opening and press down
firmly on all sides to compress putty.
 From beneath the sink, slip the rubber and foam washers over
the strainer cup.
 Align the strainer body with the strainer cup and re-connect the
cup to the body by threading the bolt into the center of the cup.
(This step may require two people.)
 Tighten the center bolt with a screwdriver for a secure seal.
3
Installing the push button control
 Choose the desired metal push button finish (chrome or stainless
steel). From underneath the sink, slide the black cable through
the opening and re-thread the metal push button assembly onto
the black cable. Make sure the rubber washer is on the underside
of the push button assembly (as shown in diagram).
 From underneath the sink, connect the long white threaded
piece up through the opening and screw onto the push button
assembly.
 Place the push button assembly and the white threaded piece
into the sink opening and screw the mounting nut from under-
neath the sink until the push button assembly is secured. Hand
tighten, plus 1/4 turn.
NOTE: Do not use a wrench for the step above to avoid overtightening
and/or damage to the plasic pieces.
Flange
Black
cable
4
Please contact 1-855-HD-GLACIER for further assistance.
Push
button
White
threaded
piece
Strainer
basket
Foam
washer
Rubber
washer
Strainer
cup
Push button
assembly
Rubbe r
washer
Mounting
nut
White
threaded
piece
Black
cable
HOMEDEPOT.COM/GLACIERBAY