Periodic Maintenance Hdd Crusher; (Every 10.000 Cycles) - Intimus 360 Destroyer Instrucciones De Uso

GB
Cleaning the Debris Tray:
1 . Make sure destruction wedge has returned to the
top or home position. Wait for motor to stop.
2 . Switch off the machine and disconnect the power
cord.
3 . Open Door and remove the Hard Drive(s).
4 . Sweep debris from side rails into Debris Tray.
5 . Lift and remove Debris Tray.
6 . Empty Debris Tray into trash container.
7 . Check bottom of crush chamber for debris.
If additional debris is found use a small brush to
move it to the front of the destruction chamber.
There are two holes that allow debris to be swept
out of the floor of the destruction chamber.
Note: Placing the Debris Tray under the front of
the intimus 360 Destroyer will catch the debris as it
falls from the two holes in the front of the destruc-
tion chamber. (See "Cleaning Tip" below).
8 . Replace the Debris Tray, connect power cord, and
resume the destruction process.
NOTE!
Make sure that the Debris Tray is inserted all
the way to the back of the chamber or the
door will not shut completely.
Cleaning Tip: You can use the debris tray itself to
clear remaining debris from the bottom of the intimus
360 Destroyer as demonstrated in the images below
(Fig. 13).
Fig. 13 Tip: Use debris tray for cleaning
94926 01 05/18
8 .3 Periodic Maintenance HDD crus-
her (Every 10 .000 cycles)
DANGER!
Risk of death by electrocution!
) Before performing any maintenance on
Greasing the Drive Shaft
Remove the left side of the intimus 360 Destroyer/360
Crusher by removing 11 screws with a T-20 torx driver
(Fig. 1). Locate the knurled brass knob and rotate ½
turn clockwise.
Fig. 14 Greasing the Drive Shaft
This will automatically apply grease to the drive shaft.
Greasing the Vertical Crusher Slide Rails
Lift the door and apply a small coat of white lithium
grease on each vertical crusher slide rail with a Q-tip.
Spread until a thin layer of grease coats the entire rail.
Repeat on each of the four rails.
000166
Fig. 15 Greasing the Vertical Crusher Slide Rails
Cleaning the Air Filters
Remove the side air filter housing by hand and clean
any major debris off foam filter. Use canned-air to blast
any dust or debris from filter. Replace foam filter in
plastic housing and firmly reattach to side panel by
ensuring all 4 plastic tabs securely latch to adjacent
filter frame.
360 Destroyer / 360 Crusher
the intimus 360 Destroyer/360 Crusher,
turn the unit off and unplug the power
cord from the electrical outlet!
000170
000171
17