Toya POWER UP 79237 Manual De Instrucciones página 10

PROPERTIES OF THE TOOL
Multi-purpose oscillating tool is a regular electric tool of the 2nd insulation class designed principally for finishing works at wood,
plastics and metal processing, particularly in corners and in areas which are difficult to reach. The tool permits to cut, grind, clean
surfaces and polish with an adequate insertion tool. Under no circumstances may the tool be used for the purpose of processing
other materials than those mentioned above, e.g. for grinding of finishing coats, fibre-reinforced putty, etc. The tool has been
designed exclusively for domestic use and must not be applied for professional purposes, i.e. in factories or for profitable jobs. A
correct, reliable and safe functioning of the grinder depends upon its adequate operation, and therefore:
Before you proceed to use the tool, read the whole manual and keep it.
Attention! Dust generated while grinding certain surfaces may be harmful and even toxic.
The note above regards for example grinding surfaces coated with lead-containing paints, certain kinds of woods, some metals
(e.g. lead) and materials, and therefore during work it is necessary to apply an efficient dust extraction system, dust masks and
other means of protection of the skin and respiratory system. The supplier shall not be held responsible for any damage due to
failure to observe safety regulations and the recommendations included in this manual.
EQUIPMENT
The tool is provided complete and it does not require assembly, save for installation of the insertion tool described below.
The tool is supplied with accessories.
TECHNICAL PARAMETRES
Parameter
Catalogue number
Mains voltage
Mains frequency
Nominal power
Number of oscillations
Mass
Level of noise
- acoustic pressure L ± K
pA pA
- acoustic power L ± K
wA wA
Class of insulation
Vibration a ± K
h
Grade of protection
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fire or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain inflammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fire in case of contact with inflammable gases or vapours.
Do not allow children and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fit the mains socket. Do not modify the plug. Do not use any adapters what-
soever in order to adapt the plug to the socket. Unmodified plug which fits the socket reduces the risk of an electric shock.
Avoid contact with grounded surfaces, such as pipes, heaters and refrigerators. Grounding of the body increases the risk
of an electric shock.
Do not expose electric tools to precipitation or humidity. Water and humidity which gets into the electric tool increases the
risk of an electric shock.
Do not overload the power supply cable. Do not use the power supply cable in order to carry the tool or to connect and
disconnect the plug from the mains socket. Avoid contact of the power supply cable with heat, oils, sharp tools and
moving elements. Damage to the power supply cable increases the risk of an electric shock.
In case work is realised outside closed areas, it is necessary to use extension cords designed for applications outside
O R I G I N A L
10
GB
Unit of measurement
[V]
[Hz]
[W]
[min -1 ]
[kg]
[dB(A)]
[dB(A)]
[m/s ]
2
I N S T R U C T I O N S
Value
79237
~230
50
250
21 000
2
86 ± 3
97 ± 3
II
6,48 ± 1,5
IP20