GE Whatman Mini-UniPrep G2 Syringeless Instrucciones De Uso página 2

Instructions for Use
Before you start, remember to select the Mini-UniPrep
G2 Syringeless Filter that is compatible with your
sample (see Chemical Compatibility Guide in appendix
1).
Step 1
Insert up to 8 glass
chambers into the Multi
Compressor tray.
Step 2
Dispense the sample into
the glass chamber taking
care not to overfill. The Mini-
UniPrep G2 glass chamber
has a maximum capacity of
500 µl indicated by the "Fill
Line" on the glass chamber.
Minimum sample volume
that may be added to the
glass chamber is 220 µl in
order to collect 50 µl in the
glass insert.
Step 3
Place plunger(s) into
the neck of the glass
chamber(s). Do not attempt
to depress further than the
neck of the glass chamber.
Step 4
Place the tray into position
on the Multi Compressor
using the guide ribs for
placement. Ensure tray is
securely in place.
Step 5
Steadying the Multi
Compressor with the left
hand as shown pull the
handle towards the user to
fully depress the plunger(s)
into the chamber(s).
Step 6
Steadying the Multi
Compressor with the left
hand as shown, rotate the
handle back to original
position enabling the tray to
be removed.
Step 7
Remove Mini-UniPrep G2
device or devices.
The Mini-UniPrep G2 prepared sample is now ready
for analysis. Process in either of two ways:
A: Place the Mini-UniPrep G2 into an autosampler
that takes standard 12 mm × 32 mm profile
vials for automated sample injection into your
instrument. Before your run, ensure that the
autosampler needle height is set to a minimum
height of 5 mm, to avoid contact with the bottom
of the inner glass insert.
B: Pierce the septum and draw the filtered sample
into a syringe for manual injection into your
instrument.
For optimum performance, the assembled and filled
Mini-UniPrep G2 device should be kept in an upright
position and not be subjected to excessive agitation to
prevent the sample being spilled out of the protective