Publicidad
Idiomas disponibles
Idiomas disponibles
3
Figure 4
Figure 5
PAGE 4 OF 12
ASSEMBLY CONTINUED
7
8
1-800-295-5510
uline.com
7. Insert legs (3) into the corner between the bottom
and the side. Bolt the leg to the side using 2 bolts
and nuts per leg. (See Figure 4)
8. Place door and frame assemblies (7 & 8) over the
locker body. Make certain that body sides are
inside frames, not between the frames. Attach top
to frame header and the bottom to frame sill (one
bolt each). Finish attaching the frame using 16 bolts
and nuts. (See Figure 5)
9. Stand unit upright and place in desired location.
10. Check and tighten all bolts.
SECURING UNITS
1. Anchor units to wall or floor. Unanchored units may
fall over if not secured. (Units standing back to back
should be bolted together.)
CAUTION: Care must be taken to assure
that lockers are set plumb and true before
anchoring.
2. If units are not pre-numbered, optional number
plate (9) may be attached with two push plugs (10).
0821 IH-1224
Publicidad
