EAS ELECTRIC EHF201 Manual De Instrucciones página 20

OPERATING INSTRUCTIONS
Switching On and Setting Temperature
1. lnsert the plug into the power socket. The power light will turn on.
2. Turn the power dial to the desired setting:
FAN - Fan only mode
LOW - Low heat mode (900W)
MEDIUM - (1300W)
HIGH - High heat (2000W)
3. Turn the temperature control dial until you hear a click, which means the unit
is on. Continue turning the dial to your desired temperature. The temperature
control dial acts as a thermostat. Once the room has reached the desired
temperature, the unit will switch off.
Fan Only Mode
For fan only mode, turn the power and fan control dial to FAN MODE.
Switching Off
1. Turn the power and fan control dial to the OFF position.
2. Tum the temperature control anticlockwise to the lowest setting.
3. Remove the power plug from the power socket.
Overheat Protection
lf the heater overheats, the thermostat built into the appliance will automatically
cut off the power supply to the heater and the heater will turn off. The heater will
need to cool down for 10-20 minutes. One the heater has cooled down it can
again be used normally. Overheating of the appliance can occur during improper
use or in certain environmental conditions.
Tip-over Protection
When the heater is knocked over or tipped onto its side, the safety switch will
automatically cut off the power supply to the heater. Power will return to normal
when the unit has been placed in an upright position and onto an even surface.
CLEANING, MAINTANANCE & STORAGE
WARNING: ALWAYS TURN THE HEATER OFF, UNPLUG THE POWER
CORD FROM THE ELECTRICAL OUTLET AND ALLOW THE APPLIANCE TO
COMPLETELY COOL DOWN BEFORE HANDLING OR CLEANING IT.
CAUTION: DO NOT ALLOW WATER OR OTHER LIQUIDS TO RUN INTO THE
INTERIOR OF THE HEATER, AS THIS COULD CREATE A FIRE AND/OR
ELECTRICAL HAZARD.
CAUTION: DO NOT USE ANY ABRASIVE CLEANERS OR SOLVENTS, AS
HEATER DAMAGE WILL OCCUR.
8 V.1