Technical Data - Sthor 82951 Manual De Instrucciones

SUMMARY OF THE PRODUCT
Car vacuum cleaner allows for cleaning the inside of cars, caravans, boats, and other interiors, which are equipped with a system
of direct current voltage of 12 V. The vacuum cleaner is equipped with a removable air fi lter. The product is not intended for com-
mercial use. Correct, reliable, and safe operation of the tool is dependent on proper use, therefore:
Prior to working with the tool, you should read all the instruction and keep it around.
For any damage or injuries caused by failure to comply with safety regulations and instructions of this manual, the supplier is not
responsible.
PRODUCT EQUIPMENT
The product is supplied in a complete state and requires no assembly. Along with the product there is delivered the
hose and suction nozzles, as well cloth bag allowing to pack vacuum cleaner with accessories.

TECHNICAL DATA

Parameter
Catalogue No
Mains voltage
Rated power
Hose length
Insulation class
Weight
Fuse
GENERAL SAFETY CONDITIONS
The device can be used by children at age of 8 years and older and persons with reduced physical, sensory, or mental abilities,
also by people with lack of experience and knowledge, if there is exercised supervision over them, and if there have been com-
municated to them instructions for safe use and they understand the risks.
You should supervise the children to not play with the appliance. Cleaning and maintenance should not be performed by children
without supervision.
The vacuum cleaner is designed for dry operation. It is forbidden to suck water, wet ash or other wet waste. This may cause an
electric shock, which in result may pose a threat to the health and life for the user and bystanders.
Never suck hot, glowing or fl aming objects. This can cause a fi re or explosion, and expose you to serious injury or death. The
maximum temperature of sucked impurities must not exceed 40 °C.
The device is designed to work indoors and should not be exposed for water, including the rain.
Before connecting the power cord plug of device, make sure that the parameters of the mains correspond to the parameters
visible on the nameplate.
Before each use, check the device status, including the state of power cord and plug. If you notice any faults, do not use the
device. Damaged cables and wires must be replaced with new ones in a specialized workshop.
Prior to the maintenance of the equipment, make sure that the power cord has been disconnected from the mains socket.
The device should be stored out of reach for bystanders, especially children. Also during the operation a special care should be
taken that the device was in a place inaccessible to unauthorized persons, especially children.
Transfer device with a handle, do not move it by pulling the cord.
You should regularly check the condition of the hose. It is forbidden to use a vacuum cleaner with a damaged hose.
OPERATION OF THE DEVICE
Preparing for operation
Check the vacuum container, if it is necessary empty the waste.
Check the condition of the fi lters. Vacuum cleaner has two types of fi lter i.e. internal and external. IIf the fi lters are dirty, dry clean
with a compressed air stream of no more than 0.3 MPa or wet under a stream of running, lukewarm water. Do not clean the fi lters
in dishwashers or with a high-pressure water jet. If dirt cannot be removed from the fi lter, replace them with The telescopic tube
allows to adjust new ones. Check the fi lter gaskets if they show any damage, fi lters should be replaced.
NOTE! It is prohibited to work with a vacuum cleaner without properly mounted air fi lters. This can lead to damage of the vacuum
cleaner and electric shock.
O R I G I N A L
GB
Unit
[V]
[W]
[cm]
[kg]
I N S T R U C T I O N S
Value
82951
12 DC
100
70
III
0.9
6 x 30 mm, 15 A / 250 V, BGDP
7