Publicidad
Idiomas disponibles
Idiomas disponibles
How to Stop Your
Pressure
Washer
1.
Let engine idle for two minutes.
2.
Move throttle lever on engine to "Stop" position.
3.
ALWAYS point gun in a safe direction and
squeeze spray gun trigger to release retained high
water pressure.
IMPORTANT: Spray gun traps high water pressure,
even when engine is stopped and water is disconnected.
.
Keep
high pressure
hose connected
to pump
and spray
gun while
system
is pressurized.
ALWAYS
point
gun in safe direction
and squeeze
spray
gun trigger,
to release
high pressure,
every time
you stop
engine.
Engage
trigger
lock when not in use.
Engage trigger
lock
on spray
gun
when
not in use.
How to Use Accessory
Tray
The unit is equipped with an accessory tray with
places to store your nozzle extension, spray gun,
turbo nozzle, and ProjectPro
TM
nozzles. There is also
a hook at the front of the accessory tray to hold your
high pressure hose.
NOTE: The extra hole in the tray is for storing a utility
brush. The brush is NOT included with your pressure
washer. You can buy the brush as an optional accessory.
1.
Place nozzle extension through hole on accessory
tray, as shown.
Typical Pressure
Washer Shown
How to Use ProjectPro
TM
Nozzle System
The quick-connect
on the nozzle extension allows you
to switch between four different ProjectPro
TM
system
nozzles. The ProjectPro
TM
nozzles vary the spray
pressure and pattern as shown.
Low
Pressure
Black
Use to apply
detergent
High Pressure
Delicate
General
40 ° Yellow
15° Orange
1650 PSi
1950 PSI
2.2 GPM
2.1 GPM
Max
0 ° Red
2200 PSI
1.9 GPM
Follow these instructions to change
ProjectPro
TM
nozzles:
1.
Engage trigger lock on spray gun.
CAUTION
.
.
NEVER exchange ProjectPro
TM
nozzles without
engaging the trigger lock on the spray gun.
DO NOT twist ProjectPro
TM
nozzles while spraying.
Pull back collar on quick=connect
and pull current
ProjectPro
TM
nozzle
off. Store ProjectPro
TM
nozzles
in holder
provided
on the accessory
tray.
Select desired
ProjectPro
TM
nozzle:
•
For delicate
rinse (lower pressure
and higher
flow), for gentle
cleaning
of cars/trucks,
boats,
RV's, patio furniture,
lawn equipment,
etc.,
select
yellow
Delicate
ProjectPro
TM
nozzle.
2.
Place spray gun through hole on accessory tray
on right side of unit.
3.
Push turbo nozzle up and into clip on accessory
tray until it snaps in as shown.
4.
Hang high pressure hose on hook attached to
accessory tray on front of tray as shown.
5.
Insert multi-colored
ProjectPro
TM
nozzles in
spaces provided in accessory tray.
11
Publicidad
