Connecting To A Dvd Player; Using Side Av Connectors; Using Other Connectors; Remote Control Handset - CONTINENTAL EDISON 107FHD42V Manual De Instrucciones

Connecting to a DVD Player

If you want to connect a DVD player to your LCD
TV, you can use connectors of the TV set. DVD
players may have different connectors. Please refer
to your DVD player's instruction book for additional
information. Power off both the TV and the device
before making any connections.
Note: Cables shown in the illustration are not
supplied.
• If your DVD player has an HDMI socket, you can
connect via HDMI. When you connect to DVD player
as illustrated below, switch to HDMI source. See,
"Input Selection" section.
• Most DVD players are connected through
COMPONENT SOCKETS. Use a component video
cable to connect video input. For enabling audio,
use a component audio cable as illustrated below.
When the connection is made, switch to YPbPr
source. See, "Input selection" section.
• You may also connect through the SCART 1 or
SCART 2. Use a SCART cable as shown below.
Note: These three methods of connection perform the
same function but in different levels of quality. It is not
necessary to connect by all three methods.
01_MB61_[GB]_3900UK_IDTV_BRONZE16_42905W_10070163_50176777.indd 10 01_MB61_[GB]_3900UK_IDTV_BRONZE16_42905W_10070163_50176777.indd 10

Using Side AV Connectors

You can connect a range of optional equipment to
your LCD TV.
• For connecting a camcorder, connect to the VIDEO
IN socket and the AUDIO SOCKETS. Do not connect
the camcoder to VIDEO IN socket at the same time
since it can cause noise in the picture. For selecting
the related source, see the section "Input selection"
in the following parts.
• To listen the TV sound from headphones, connect
to the HEADPHONE jack of theTV.

Using Other Connectors

You can connect a range of optional equipment
to your LCD TV. Possible connections are shown
below. Note that cables shown in the illustration are
not supplied.
• For connecting a to a device that has SPDIF support,
use an appropriate SPDIF cable to enable sound
connection.

Remote Control Handset

Inserting Batteries

• Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
• Insert two AAA/R3 or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
Note: Remove the battery from remote control
handset when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.
English - 10 -
06.10.2010 09:16:19 06.10.2010 09:16:19