Controls And Operation; Knobs And Buttons (Fig. 4) - Bosch GPB18V-2C Instrucciones De Funcionamiento Y Seguridad

Fig. 4

Knobs and Buttons (Fig. 4)

USAGE TIP: For the easiest operation of
buttons 3, 4, 5, 6, 11, press the section
of these buttons that is closest to the
LCD screen.
1. ON/OFF BUTTON / KNOB
Press the knob to turn the unit on or off.
If Bluetooth was the active source at the
time the unit was turned off, the unit
will attempt to re-establish the
Bluetooth connection for up to 19
minutes, if necessary.
VOL (Volume) Knob – To increase/
decrease the audio volume when any
source or special mode is in use. Volume
adjusts from 0–30 (min–max). Knob
rotates 360-degrees.
2. LCD SCREEN
3. BLUETOOTH® BUTTON
Bluetooth Pairing – Pressing the
Bluetooth button for 0.5 seconds when
any source is active causes the source
to change to Bluetooth and starts the
pairing process. The Bluetooth symbol
with flash rapidly during this process.
Activate the Bluetooth pairing process
on the smart phone or other smart
device that is to be paired with the
GPB18V-2C. Once the pairing is
complete, the audio will begin and the
flashing of the Bluetooth symbol will
stop.

Controls and Operation

20
1 2 3 4
-11-
11
5 6 7
When a device is paired to the unit:
– a press of the Bluetooth Button for
less than 0.5 seconds has no effect,
– a press of the Bluetooth Button
greater than 0.5 seconds will start a
new pairing process,
– a press of the Bluetooth Button over 1
second and the unit will go to look for
another new device to pair with.
To exit the pairing mode, press the
Bluetooth button.
4 & 5. (DOWN) &
AM/FM Tuning
• When either of these buttons is
pressed for less than 0.5 seconds,
the radio seeks the next strong signal
in the chose direction, down or up*.
• When either of these buttons is
pressed for 0.5 seconds or longer,
the radio starts a scan mode: the
radio seeks the next strong signal and
plays it for five seconds, and then
repeats the process for the next
strong station, etc. At any point in the
scanning process, a press of either
the or
mode and
frequency.*
* When the seek or scan activity reaches
the highest or lowest frequency, the
radio automatically continues in the
same direction at the other end of the
frequency range.
(UP) BUTTONS
button ends the scan
plays the current