Switching On/Off; Unit Setting - Agatec DM100 Manual Del Usuario

8.2 Switching on/off

Switch on the device by pressing key 4 briefly.
The device shows the battery symbol until another key is pressed.
Switch off the device by holding key 7 for several seconds.
If no key is pressed for 180 seconds, the device switches off automatically.
8.3 Clear key
Undo the most recent action by pressing key 7 briefly.
8.4 Adjusting the measuring plane
See drawing F - H:
Rear measuring plane is the standard setting.
For measurement from front edge, press key 8 briefly.
For measurement from rear edge, press key 8 briefly again.

8.5 Unit setting

Metric system is the standard setting.
To change the unit, hold key 8 for several seconds.
With every keypress, the device switches to the next unit.
Possible units:
meters with mm display
feet inch fractional
summary row up to 1/16 inch
second row up to 1/8 inch
inch fractional
summary row up to 1/16 inch
second row up to 1/8 inch
9 Measuring
9.1 Measuring single distances
Press key 4 briefly.
Aim active laser at target area.
Press key 4 briefly.
The device measures the distance.
The device displays the result immediately.
7/70