GLOBBER GO BIKE DUO Manual Del Propietário página 9

To get a low frame positioning: (Diagram A)
1. Get the frame with the curve facing downward (see diagram
"A")
2. Insert the wheel fork into the frame's stem. Next, add the white
plastic gasket and the front reflector on to the wheel fork.
3. Insert the handlebars' stem into the fork's stem, the minimum
insertion depth for the handlebars is where "MIN" is marked on
the stem when placing the handlebars into the fork's stem. This
is the highest height of the handlebars.
4. After fixing the handlebars' height, tighten the screw behind the
front reflector with an Allen key.
* Careful: make sure to tighten the screw into the front reflector,
to securely fix the handlebars.
5. Insert the saddle stem into the saddle tube of the balance bike
frame. The minimum insertion depth for the saddle is where
"MIN" is marked on the stem when placing it into the frame's
saddle tube. This is the highest height of the saddle. Tighten
with the knob to fix the seat height.
* Careful: make sure to tighten the knob in order to securely fix
the saddle.
6. Insert the footrest to the bottom of the saddle tube and tighten
the knob. When the footrest is removed, insert the end cap,
which is included in the spare parts bag, to cover the hole
underneath. Once the end cap is inserted, tighten it with the
knob to securely fix it to the balance bike.
If you want to swap to 1 rear wheel for advance balancing in a low
frame positioning, you can do so by following step 10.
To get a high frame positioning: (Diagram B)
7. Get the frame with the curve facing upward (see diagram "B").
8. Follow steps 2 to 5 above to assemble the balance bike in high
frame position.
9. Since the footrest is not recommended to be used in the high
frame position for older kids, you can remove it and replace it
with the end cap, which is included in the spare parts bag, to
cover the hole underneath then, tighten it with the knob.
To transform the dual-rear wheel to a single rear wheel:
(See page 5)
10. Place the GO BIKE DUO upside down. Unscrew the wheels
with 2 Allen keys, which are included in the spare part bag,
then pull out the long screw to remove both rear wheels as
well as the spacers.
11. Keep 1 wheel to install it on the rear of the balance bike.
Take the 2 longer spacers and the long screw to prepare the
installation of the wheel.
12. Insert the long screw and the first spacer in the hole. Align
the holes inside the bearing to insert the long screw into the
bearing on the rear wheel. Next, add the second spacer on the
other side of the rear wheel.
* Careful: Make sure the spacers, the wheel and the bearing
are aligned before inserting the long screw. To align the
spacers, the wheel, and the bearing, use the Allen key, which
is included in the spare parts bag, to help to align them before
inserting the long screw inside the spacers of the rear wheel.
13. Tighten the rear wheel with the 2 Allen keys, which are
included in the spare parts bag. Make sure the screws are
securely tightened before using the GO BIKE DUO.
9