Ryobi AC14RL3A Manual Del Usuario

DC TRIMMER REPLACEMENT SPOOL
AC14RL/AC80RL
WARNING:
To reduce the risk of injury, user must read and under-
stand the operator's manual for their tool. Always wear
eye protection with side shields marked to comply with
ANSI Z87.1. Failure to do so could result in objects being
thrown into your eyes, resulting in possible serious injury.
 Remove the battery pack.
 Push in tabs on side of spool retainer.
 Pull spool retainer up to remove.
 Remove the old spool.
 To install the new spool, make sure the string is captured in the slot on the new spool.
Make sure the end of the string is extended approximately 6 in. beyond the slot.
 Install the new spool so that the string and slot align with the eyelet in the string head.
Thread the string into the eyelet.
 Pull the string extending from the string head so the string releases from the slot in the
spool.
 Reinstall the spool retainer by depressing tabs into slots and pushing down until spool
retainer clicks into place.
987000-877
3-31-18 (REV:06)