Würth XP 3 Traducción Del Manual De Instrucciones De Servicio Original página 11

Power display [5]
The power display comprises ten LEDs that illuminate
in blue or red and are arranged in a circle around
the two concentric charging contacts at the end of
the LED lamp.
Shortly before the power module [3] is di-
■
scharged, the last LED briefly illuminates in red
• The LED lamp must now be charged!
Press the charging contacts:
■
Battery level display
(in switched off state)
3 e.g. ten illuminated LEDs
• LED lamp is charged
• Charging time display (when switched on)
3 The number of illuminated LEDs gives an indica-
tion of the remaining relative light duration of
the current light function
3 Information is also displayed, if a light function
has been selected by touching or pressing the
switch
Use [Fig. I]
Press
Press the on/off switch [2] beyond the pressure
■
point
3 The on/off switch [2] engages with a click
Touch
Lightly touch the on/off switch [2]
■
3 The on/off switch [2] does not engage
Light functions
POWER:
Switch the LED lamp on by pressing once
■
After pressing again, the LED lamp is again
■
switched off
LOW POWER:
Touch the on/off switch [2] once and then press
■
within a second
LOW POWER can also be obtained by pres-
■
sing quickly three times
DEFENCE STROBE:
Touch the on/off switch [2] twice and then
■
press within a second
The DEFENCE STROBE function can also be
■
obtained by pressing quickly five times
Focus
The LED lamp can be continuously focussed by
sliding the lamp head [1] forward and backwards.
If necessary a desired focus setting can be locked
using the fast lock function.
Turn the lamp head [1] to the left (lock position)
■
To release the lock again, turn the lamp
■
head [1] to the right (unlock position)
Emergency mode / emergency light
function
Connect the LED lamp to the connected char-
■
ging socket [IV]
3 The blue marker light of the charging so-
cket [IV/7] illuminates
3 If the mains voltage fails, the LED lamp illumina-
tes automatically
3 If the emergency light function is activated, the
LED lamp continues to shine, as soon as it is
taken out of the charging fixture [V] and the
charging process is interrupted
Touch the on/off switch [2] six times and then
■
press
3 Emergency mode activated
3 The LED lamp illuminates for a moment in the
POWER lighting function and then flashes two
or four times
• 4 x flashing: Emergency mode activated
• 2 x flashing: Emergency mode deactivated
Repeat the process to change between the
■
activated and deactivated setting
Reset function
Disconnect the power module [3] (lamp barrel
■
with Xtreme power battery) from the lamp
head [1] and only reconnect after a short time
delay
3 LED lamp settings are reset
3 Emergency Mode light function is activated
11