Photo Mode - ION 4K Manual Del Usuario


Record Slider Lock: The small switch on top of the Record Slider is used to keep the Record
Slider from turning on or off. To move the Record Slider forward or back, have the Record
Slider Lock moved so that the red square is not showing.

11. PHOTO MODE


Activate Instant Photo Mode: Press and hold the Status Button for three seconds. You will
hear two beeps and see the photo LED will turn green, indicating that Instant Photo Mode has
been activated.

Taking a Single Photo: press the Status Button can take a single photo. You will hear a beep
and the photo LED will flash to indicate that a photograph has been taken.

Turn off Instant Photo Mode: Turn off Instant Photo Mode by pressing and holding the status
button for two to four seconds. The camera will beep three times and the photo LED will flash
and then turn off, indicating that Instant Photo Mode is turned off.

The camera will shut down automatically if no photo has been taken within 60 seconds.
12. MOUNTING
Getting the best shot depends only on your creativity. iON offers a wide range of mounts that let you put
the camera just about anywhere, so be creative.
Remember that your iON 4K has a wide-angle lens and objects that are far away will seem smaller than
you expect in your videos.
13. ALIGNMENT
Your iON 4K has a Laser Line that helps ensure you have the horizon properly aligned in your videos.
To use, activate the Laser Line by pressing the Status Button; place your hand in front of the Laser Line
or aim it on to a flat surface a few feet in front of you and rotate the lens (up to 270°) until the Laser Line
is horizontal. When mounting the camera on your helmet or goggles, you may discover that you look
down more than you thought. It may take a few practice videos to find the right alignment.
EN-10