Descargar Imprimir esta página

Team kalorik TKG CCM 1001 Manual Del Usuario página 11

Máquina para hacer algodón de azúcar

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 26
Fax +32 2 359 95 50
Never cover the appliance with any kind of material.
Provide proper ventilation when using the appliance.
Your appliance must never be switched on through an external
timer or any kind of separate remote control system.
(*) Competent qualified electrician: after-sales department of the
producer or importer or any person who is qualified, approved and
competent to perform this kind of repairs in order to avoid all danger.
In case of need you should return the appliance to this electrician.
SHORT CORD INSTRUCTIONS
A short power supply cord is provided to reduce the risk resulting from becoming entangled in,
or tripping over a longer cord. Extension cords may be used if care is exercised in their use.
The longer cord should be arranged so that it will not drape over the counter top or tabletop
where it can be pulled on by children or tripped over.
BEFORE USE
Remove all packaging material and wipe the base with a slightly damp cloth and then
dry the base. Make sure no water penetrates into the motor unit.
Clean the bowl, the extraction head, the cotton candy sticks and the measuring spoon
with soapy water, rinse and dry thoroughly. The extraction head has to be perfectly dry in
order to ensure the perfect functioning of the appliance.
ASSEMBLY
Make sure that the switch is in off-position "0" and that the appliance is unplugged before
assembling. Put the base on a firm and level surface and put enough pressure onto the
appliance to make the suction pads stick to the work surface.
To assemble the appliance, put the bowl onto the base and turn it anticlockwise all the way to
the stop into the foreseen slots of the base in order to lock it in place. Then put the extraction
head on the metallic axle in the centre of the base, making sure that the two pins on the
metallic axle fit into the slots on the bottom of the extraction head. Push the extraction head
down firmly until it is fixed properly. Attention: make sure that the extraction head is assembled
correctly on the axle. A bad assembly may result in danger, a bad functioning or heavy
vibrations.
To work properly, the surface must be firm and level.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
11
Assembly page 11/52
TKG CCM 1001 - 131218

Publicidad

loading