Description Of Device / Spare Parts; Guarantee; Possible Faults - ATIKA KSG 220 A Manual Original

,

Description of device / spare parts

Position Denomination
1.
Rotary table, complete
2. Supporting table
3a/3b. Mounting screw (with spring)
4. Chain stop
5. Guide plate
6. Guide rail
7. Locking nut
8.
Setting screw (for grinding depth)
9. Grinding wheel (100 x 3.2 x 10 mm)
10. Cover
11. Handle
12.
ON-OFF Switch
13. Motor
14. Screw cap
15. Nut M8, self-locking
16. Flange
17. Safety label
18. 1 pair of carbon brushes (not shown)
19.
Grinding wheel (100 x 4.5 x 10 mm)
20 Protective cover
21. Nut

Possible faults

Before each fault clearance
− switch off device
− wait for the shutdown of the grinding wheel
− pull out main plug
After each fault clearance, put into operation and recheck all security installations.
Fault
Chain sharpener does not operate.
Chain sharpener grinds with interruptions
Grinding wheel becomes hot
Motor is humming, grinding wheel stops
Unusual vibrations
Order-No.
363702
363730
363704
363705
363706
363707
363708
363709
363710
363711
363712
363713
363729
391037
363715
363716
363717
363718
363720
Possible cause
no power
Extension cable defect
Main plug, motor or switch defect
Extension cable defect
Internal fault.
ON/OFF button defective.
Grinding wheel is dull or defective
Grinding wheel is blocked
Grinding wheel is defective
17

Guarantee

Please observe the enclosed terms of guarantee.
Remedy
Check power supply, power socket and fuse
protection
Check extension cable, exchange defect cable
immediately
Have motor or switch checked by an approved
electrician or replaced by original spare parts
Check extension cable, exchange defect cable
immediately
Please contact the after sales service.
Please contact the after sales service.
Replace grinding wheel
Remove object
Replace grinding wheel