Warnings And Safety - Orkli OKSOL Guía Rápida

WARNINGS AND SAFETY

Warnings
• If leakage from the system occurs, close the shut-off valve at the system inlet and contact the
installer immediately.
• The solar unit is protected against frost by a thermal fluid. Use only the thermal fluid provided by
ORKLI S. Coop.
• Check the minimum temperature achievable on the system location and refill with the proper
amount of thermal fluid (described in the installation manual).
• This document is part of a solar powered system and must be kept in good condition.
If it is lost or destroyed, contact your supplier for a new one.
• The solar system must be installed and commissioned by a professional installer. The installer must
sign the warranty document. Installers are responsible for ensuring the correct installation and
commissioning in accordance with regulations.
• There is a risk of severe burns for persons coming into contact with heat transfer fluid conductive
elements, as these components become very hot when operating in solar mode.
Basic safety rules
• Do not install the solar system on a flat or sloping roof without following the general safety rules.
• Do not change the settings of the safety valves. Verify that the system operates properly.
• Do not make any changes to the system or its components, and do not replace system parts
without the prior approval of ORKLI S. Coop.
• Do not allow excess anti-freeze to evaporate or discard it. Do not allow children near the system.
• Do not interconnect or drill into the internal circuit of the solar system.
• Do not work on the primary and secondary circuits when heat levels are high, whether the
circulating pump is operating or stopped.
• The installation must be fitted with a thermostatic mixing valve at the outlet of the domestic hot
water to prevent overheating dangerous to the user.
"Waste for this EEE (Electronic Electrical Equipment) is collected separately in
order to minimise the disposal of EEE (WEEE) as unsorted municipal waste."
8