Technical Support - Kensington PresentAir Pro Guía Rápida

Need More?
For additional instructions and
disclosures, see the full Instruction
Guide online at:
www.kensington.com/man/K72448

Technical Support

Technical support is available to all
registered users of Kensington
products. Technical Support contact
information can be found on the back
page of this manual.
Web Support
You may find the answer to your problem
in the Frequently Asked Questions (FAQ)
section of the Support area on the
Kensington Website: www.support.
kensington.com.
Telephone Support
There is no charge for technical support
except long-distance charges where
applicable. Please visit
www.kensington.com for telephone
support hours. In Europe, technical
support is available by telephone
Monday to Friday 09:00 to 18:00 (Central
European time).
Please note the following when calling
support:
• Call from a phone where you have
access to your device.
• Be prepared to provide the following
information:
– Name, address, and telephone
number
– Name of the Kensington product
8
– Make and model of your computer
– System software and version
– Symptoms of the problem and what
led to them
CLASS 2 LASER SAFETY STATEMENT
650+/- 20nm
1. Emission of a parallel beam of visible light;
2. Maximum Power of 1 milliwatt CW, wavelength
range 650±20 nanometers;
3. Operating temp between 0 ° C (32° F) to 40° C (104°
F).
• Do not disassemble the device
• Do not use the device outside of its specified
operating temperature range. If the device is
exposed to an environment outside of its
prescribed operation, turn off the device and
allow the temperature to stabilize within the
specified operating range before using the device.
FEDERAL COMMUNICATION COMMISSION
INTERFERENCE STATEMENT
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) This device must accept any interference
received, including interference that may cause
undesired operation.
FCC RF RADIATED EXPOSURE STATEMENT
This device has been evaluated to meet general RF
exposure requirements. The device can be used in
portable exposure conditions without RF restrictions.
Modifications: Modifications not expressly approved
by Kensington may void the user's authority to
operate the device under FCC regulations and must
not be made.
Shielded Cables: In order to meet FCC requirements,
all connections to equipment using a Kensington
input device should be made using only the shielded
cables.
This laser device complies
with International Standard
IEC/EN 60825-1: ED 2. 2007,
Class 2 Laser Product and also
complies with 21 CFR 1040.10
and 1040.11, except for
deviations pursuant to laser
Notice No. 50, dated June 24,
2007:
9