Intimus PL-100 Instrucciones De Uso página 7

GB
2 Laminating instructions
1. Connect the power plug to a socket outlet (A).
¾ The red LED indicator „COLD" flashes slowly. Machine is in sleep mode.
2. Touch the On/Off touchbutton lightly (B). Try to create a large contact surface with your finger.
¾ The red LED „COLD" flashes quickly. The machine starts to hum very quietly.
3. Touch the touchbutton „HOT" several times (C) to select the desired laminating mode: 75/100 mic
oder 125 mic.
¾ The corresponding blue LED indicator flashes as long as the device heats up.
4. Preheat the machine (about 1 minute) until the blue LED indicator lights up permanently (D).
5. Insert your document into the laminating pouch and feed the pouch into the laminator, sealed end
first. The pouch will pass between the heated rollers, which will simultaneously melt the adhesive
and apply pressure, to create a seal (G).
6. When the pouch comes out the back of the machine, place it on a flat surface to cool. This will help
to prevent wrinkles or bubbles forming in the pouch.
7. Feed any additional pouches through the machine. If the blue LED indicator flashes, let the machine
heat up again until the light comes back on before inserting another pouch, to ensure proper lami-
nation
8. To change the lamination mode, touch the „HOT" touchbutton again.
9. To finish laminating, touch the On/Off touchbutton (H).
¾ The red LED indicator „COLD" flashes slowly. Machine is in sleep mode. The machine stops huming.
10. Unplug the power plug.
95443 2 10/19
7
PL-100
000379