Adding A New Handset; Removing A Handset; Select A Base - OGATECH OG-R400 Manual De Usuario

9.8.2 To set and select the sending SMS Centre number
• From the standby screen, press SMS to open the SMS menu.
• Scroll to Settings and press OK.
• Press OK to open Service Centres menu.
• Scroll to Sending Centre and select OK.
• The current stored number will be shown. Press Clear and enter the new number.
• Press OK to store the number.
10ADDITIONAL HANDSETS AND BASES
You can subscribe up to 5 handsets on a OGATECH OG-R400 base. Each handset can
register to 4 base stations and the user can select which base he wants to use.

10.1 ADDING A NEW HANDSET

!! Only needed when you have deregistered a handset or when you bought a
new one !!
First put the base into registration mode:
• Press and hold the paging
• The LED will start to blink on the base for 90 seconds. During that time the base is
ready to register a handset.
On the handset:
• Select Menu to open the menu.
• Select Registration with the navigator and press OK.
• Select Register Handset with the navigator and press OK.
• Select the number of the base to be associated with the handset (1 to 4). Confirm by
pressing OK.
• Enter the system PIN (0000 by default) and confirm with OK. A series of numbers
appears on the screen, representing the base ID. Confirm with 0K. Your handset is
registered.

10.2 REMOVING A HANDSET

This procedure needs to be carried out on a different handset from the one you want to
uninstall.
• Select Menu by pressing the left menu key.
• Select Registration with the navigator and press OK.
• Select De-register with the navigator and press OK. Enter the system PIN (0000 by
default) and press OK.
• Select the handset to uninstall with the navigator and press OK.

10.3 SELECT A BASE

You can switch your OGATECH OG-R400 handset between bases. You can also set it to
automatically base select with the strongest signal. The handset must first be registered with
each base individually.
• Press MENU then scroll to Registration and press OK.
• Scroll to Select Base then press OK. The current base being used is highlighted.
OGATECH OG-R400
button on the base until you hear two beeps.
OGATECH OG-R400
21