Kalorik TKG MC 1001 Manual De Instrucciones página 10

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 22
Fax +32 2 359 95 50
needed securities. Do not try to substitute one of those pieces by
another one and if you have to replace one, contact your after-
sales service.
Caution: your appliance has a security device that avoids
excessive starting. Do not try to overrule this device, as it
could be very dangerous for you.
(*) Competent qualified electrician: after-sales department of the
producer or importer or any person who is qualified, approved and
competent to perform this kind of repairs in order to avoid all danger.
In case of need you should return the appliance to this electrician.
IMPORTANT INFORMATION
This appliance is not designed for professional use. You should follow the requested breaks.
Failure to follow this instruction carefully may result in damage to the motor. Please refer to the
rating label for the maximum continuous usage time (KB xx min where xx is the allowed
maximum usage time). The breaks should last at least 10 minutes.
MOUNTING AND USE OF THE MINI-CHOPPER
Caution: for your own safety and a good functioning it is absolutely necessary to respect the
mounting described hereunder.
Place the rubber ring on a flat surface, then insert the jug in the ring.
Place the blade of the mixer fitting in the jug.
Put the ingredients in the jug.
Place the lid on the jug respecting the positioning of its openings-out. If necessary, turn the
lid until it is correctly placed on the jug.
Place the unplugged motor block on the jug respecting the positioning of the openings-
out. If the motor block is not mounted correctly, it will be impossible to start the appliance.
Plug in the appliance.
To start, press the LOW or HIGH switch with your hand holding the jug with the other hand.
To remove food, unplug and proceed the other way round, but pay attention not to get
injured, as the blade is very sharp.
TIPS FOR USE
Your appliance is not intended to work for long periods. So if your preparation requires
more than 1 minute of continuous use, it is absolutely necessary to follow breaks. The
breaks should last at least 2 minutes to allow the motor to cool down.
We advise you to chop the food by fits and starts and if necessary to mix them with a
spatula between two chopping processes following the safety instructions.
If you chop pieces of meat or cheese, we advise you to cut them into small pieces of 1 to
1.5 cm beforehand in order to obtain a homogeneous and fine chopping. Otherwise you
could obtain lumps in your preparation.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you keep
the good numbering when you turn the pages of the I/B.
Don't change the page numbering. Keep the language
integrity.
10
Assembly page 10/45
TKG MC 1001 - 150304

Publicidad

Tabla de contenido
loading

Tabla de contenido