Dynex DX-MP3FM Manual De Instrucciones página 2

DX-MP3FM transmitter.fm Page 2 Thursday, September 1, 2005 2:18 PM
2
Replace the battery cover. Make sure that the cover is securely
in place.
3
To turn on the transmitter, press and hold the
button for two seconds. The transmitter turns on.
4
Press to choose a channel, then connect the transmitter to
+/-
an audio source.
5
Turn on both the audio source and the FM receiver (FM radio),
then tune your receiver to the same frequency as the
transmitter. The music from the audio source is played on your
FM radio.
Tip: The audio source can be any audio device that accepts a
3.5 mm stereo jack, so a portable CD player, MP3 player,
MD player, computer, PDA, television, and even another FM
radio can be the audio source. Since the range of the transmitter
can vary widely depending on the presence of other electronic
devices, building materials, terrain, and distance, you should
experiment on your own to determine its useful range for your
use.
6
To turn off the transmitter, press and hold the
for two seconds.
Programming frequencies into the transmitter
In addition to the preset frequencies, you can program any of the ten
memory channels to any frequency from 88.1~107.9 MHz.
To program or change a frequency on the
transmitter:
1
To turn on the transmitter, press and hold the power
button for two seconds. The most recent frequency the
transmitter used is selected and active.
2
power
button
power