Kobalt KXHD 124B-03 Manual De Instrucciones página 12

OPERATING INSTRUCTIONS
9. Installing and Removing the Belt Clip
a. Align the rib of the belt clip (I) with the hole on
the base of the hammer drill.
b. Tighten one screw (J) securely with a Phillips
screwdriver (not included).
c. To remove the belt clip, use a Phillips
screwdriver to loosen the screw holding the
belt clip to the hammer drill.
10. Auxiliary Handle
This hammer drill is equipped with an auxiliary
handle (H). For ease of operation, you can use the
handle with either the left or the right hand. The
handle can be locked in the two positions shown in
Fig 10.
To install the auxiliary handle:
a. Remove the battery pack.
b. Loosen the auxiliary handle by turning the
handle counterclockwise.
c. Align the raised portion on the auxiliary handle
with the grooves on gear box of the hammer
drill, then slide the auxiliary handle onto the tool
as shown.
d. Hand-tighten the handle by turning the handle clockwise.
To remove the auxiliary handle:
a. Remove the battery pack.
b. Loosen the auxiliary handle by turning the handle counterclockwise.
c. Remove the auxiliary handle from the tool
WARNING
• For safety and ease of operation, securely tighten the auxiliary handle before every use.
9
I
10
12
J