BUTTONS INTRODUCTION
1. Menu
: Enter and exist menu
① Press the button one time to enter to recording mode settings.
② Press twice times to enter to system settings.
③ Press third times to exist and back to the main interface.
④ On recording, press
to turn On / Off the lock which Lock / Unlock the
videos for important events.
2. Mode
: Playback
① Press
button to enter into the playback, then press
select, last press
button to confirm, press twice times
② Press
button to play the current video, press
and press
button to stop.
③ Press
buttons to select videos to play.
④ Press
button twice times to exist the playback.
3. Power
: Power switch
① Short press to Stop / Start recording.
② When setting, press
to confirm; when playback, press
③ Long press to turn On / Off the power of the camera.
4. UP
: Select the up options
5. Down
: Select the below options
On recording, press
to turn On / Off the MIC.
6. Reset: Built-in hole
① Use the needle to press into the hole.
② When the camera is stuck or unresponsive, please reset it.
03
buttons to
to exist.
button again to pause
to Play / Pause.
HOW TO POWER ON
① Insert the USB car charger into your car's cigarette lighter socket.
② Insert the USB end of the USB power cord into the USB car charger.
③ Insert the Micro USB into the dash cam USB port
(Charger is Input DC12-24V, Output DC 5V 2A).
NOTE:
① The battery takes about two hours to be charged fully.
② When the battery is charging, the indicator light on the top left of the
screen will be stayed red; When it charged fully, the light goes off.
③ The battery can last for about 10 minutes after it is charged fully.
④ The battery is mainly used to power the "parking monitoring" function. For
normal video recording, please connect the car charger to use the power
supply. It is not recommended to use battery power, in order to avoid the
battery without power and cause the parking monitoring function to fail.
⑤ To avoid damaging to the device, please do not charge the battery via the
USB data cable with other adapters.
3
2
1
04