Publicidad
Veria LED
WAS
PRECAUTIONS:
• Keep the product out of the reach of children.
• Do not immerse this product in water or handle it with wet hands.
• Do not hit the product.
• Do not install the product where there are heat sources or moisture
concentrations.
• Do not handle the product while it is in operation and allow it to cool before
touching it with your hands.
• The product must not be covered with thermal insulation material under
any circumstances.
• Maintain a minimum distance of 1m from the surface or object to be
illuminated.
• If the product is damaged, replace it immediately with a new one.
• Disconnect power before installing the product.
• This product contains components sensitive to static electricity and a
discharge to it could destroy or damage its components.
• Before carrying out any work or maintenance, make sure that the device is
completely disconnected from the power supply.
• The replacement or maintenance of any component must be carried
out with the same elements recommended and supplied by the
manufacturer himself. If this is not the case, any incident on an installation
that has not been carried out in accordance with this instruction sheet is
the responsibility of the installer.
• If the flexible cable or cord of this luminaire is damaged, it must only be
replaced by the manufacturer or its technical service or a person of
equivalent qualification in order to avoid any risk.
• The light source of this luminaire must be replaced only by the manufacturer,
its technical service or equivalent qualified person.
• The luminaire should be placed so that a prolonged look at the luminaire is
not expected at a distance closer to 4.67m.
W
LUM
40W
DEGREE OF PROTECTION
Degree of waterlightness
Impact resistance
INSTALLATION
Maximum surface wind exposed
Maximum. Height of installation
1/8
noviembre 2019
620
Nº LED
WEIGHT
32 LED
7,6Kg
IP66
IK09
0,231m
2
20m
[GRÁFICOS: Unidades en mm/ GRAPHICS: Units in mm/GRAPHIQUES: Unités en mm/GRÁFICOS: Unidades em mm]
WARNING
BEFORE INSTALLING THIS PRODUCT, PLEASE READ THE
INSTRUCTIONS CAREFULLY AND STORE THEM IN A SAFE
PLACE.
THE INSTALLATION SHOULD BE CARRIED OUT BY TRAINED
STAFF.
INCORRECT HANDLING OF THE PARTS OR THE LIGHT FIXTURE
ITSELF MAY IMPAIR THE PROPER PERFORMANCE OF THIS
PRODUCT. IN THIS CASE, THE MANUFACTURER GUARANTEE
SHALL BE DEEMED VOID.
THE MANUFACTURER GUARANTEE SHALL BE DEEMED VOID:
IF THE INSTALLATION IS NOT PERFORMED IN ACCORDANCE
WITH THE SPANISH LOW VOLTAGE ELECTROTECHNICAL
REGULATION 2002 (REBT 2002).
THE APPLICATION OF IBC BT09-4 OF REBT (INSTALLATION OF
LINE AND LIGHT FIXTURE SURGE PROTECTORS) IS ESSENTIAL
FOR INDUSTRIAL AND PUBLIC LIGHTING INSTALLATIONS.
THE GUARANTEE DOES NOT COVER AGAINST DAMAGES
CAUSED BY SURGES IN LIGHT FIXTURES WITHOUT SURGE
PROTECTORS INSTALLED.
ATTENTION!!!
OBSERVE
PRECAUTIONS
HANDLING
SENSITIVE DEVICES.
FOR
ELECTROSTATIC
Publicidad
