Uline H-6238 Manual De Instrucciones página 2

Figure 2
Figure 3
Tension Knob
Figure 4
PAGE 2 OF 9
ASSEMBLY CONTINUED
8
11
10
9
12
2. Align armrest with holes on bottom of seat cushion.
Use three 1/4 x 1/" screws (8) with three small
washers (11) to attach. Repeat on opposite side.
(See Figure 2)
NOTE: Use Allen wrench to tighten all screws.
3. Align mechanism with holes on bottom of seat
cushion with tension knob facing the front of seat.
Use four 5/16 x 7/8" screws (10) to attach.
(See Figure 3)
4. Position back support in slot between bottom of seat
cushion and mechanism. Align holes and use three
5/16 x 3/4" screws (9) with three large washers (12) to
attach back support to mechanism. (See Figure 4)
0721 IH-6238