What'S In The Box; Correct Use Of The Product - DDUUEETT COINFYCARE LOMI EL05 Manual Del Usuario

INTRODUCTION
DDUUEETT Europe SL thanks you for choosing
Coinfycare products. We hope this instruction manual
will help you to get the most out of this product.
Contact your dealer if you need clarification regarding
its use or operation.
Read the entire instruction manual carefully before
using the table. Take note of the warnings in this
manual.
Always keep this instruction manual and should you
give the table to another operator make sure you also
provide the manual since it is an essential part of the
product.
Some table parts may differ from the image that
appears in catalogues, the web, trade brochures or
other publications.
In order to make improvements to the table, the
manufacturer reserves the right to modify its
characteristics or parts without prior notice.
If, during the useful life of this table, any accident
occurs that causes or could have caused serious
injuries to the user, DDUUEETT Europe SL must be
informed immediately.

WHAT'S IN THE BOX

Electric treatment table: 1 unit
Paper Roll holder: 1 unit
Instruction Manual: 1 unit
REGULATION AND PRODUCT
STANDARDS
This table complies with the European regulation of
medical devices (EU) 2017/745 and with the following
standards:
- EN 60601-1:2006+A1:2013+AC:2014
Medical electrical equipment. Part 1: General
Requirements for Basic Safety and Essential
Performance.
- IEC/EN 60601-2-52:2009+A1:2015 clause
201.9.8.3.2
Medical electrical equipment. Part 2-52: Particular
requirements for basic safety and essential
operation of medical tables.
- EN 60601-1-6:2010+A1:2015
Medical electrical equipment. Part 1-6: General
Requirements for basic safety and essential
performance. Collateral standard: Suitability for
use.
- EN 60601-1-2:2015
Medical electrical equipment. Part 1-2: General
requirements for basic safety and essential
performance. Collateral standard: Electromagnetic
disturbances. Requirements and tests.
EN
2

CORRECT USE OF THE PRODUCT

This table has been designed for use in the field of
physiotherapy and manual therapies.
This table is intended to support users during
treatment and should not be used to transport
patients.
Do not make any changes to the table without
DDUUEETT Europe SL's authorisation.
Please note that any misuse or modification of the
table voids the warranty.
PRECAUTIONS AND SAFETY
INDICATIONS
DDUUEETT Europe SL is not liable for any material or
personal damage due to misuse or incorrect use of
this table for any purpose other than those described
in the "CORRECT USE OF THE PRODUCT" section
above.
Inspect the good condition of the table before using it
for the first time and on a recurring basis as indicated
in the "MAINTENANCE" section.
Do not use the table outdoors or in places where
it may be affected by moisture or adverse weather
conditions.
The ideal conditions for use are a temperature
between 5-40 °C, a relative humidity between 30-75%
and atmospheric pressure between 860-1060 hPa.
Do not use the table in environments where other
devices may emit electromagnetic radiation. These
radiations could affect the correct functioning of the
table.
This table can generate electromagnetic energy that
can interfere with other nearby electronic devices.
The table should be kept out of the reach of children
when there is no adult supervision.
The table is designed for discontinuous interval
operation, so the continuous running time of the
motor should never exceed 2 minutes. Should this
happen, damage may occur due to the overheating of
the electronics.
Always use original accessories and spare parts
provided by your dealer.
Always cover the table with a towel, disposable paper
or a cover and change it for each user, thus ensuring
correct hygiene and extending the useful life of the
upholstery.
Only connect the table to a properly installed and
grounded outlet. The local mains voltage must
correspond to the technical data of the device.
The power outlet should be accessible in case the
table needs to be quickly unplugged at any given time.
Always pull the plug and not the mains cable.
Unplug the table from the power supply before
starting cleaning or any type of maintenance
operations.