Inspections Before Starting Work; Usage Of The Load Lifting Attachment; Inspection / Service - Yale TIGRIP Manual Del Usuario

I B
NSPECTIONS
Ensure that the surface of the load, in the location where the load lifting attachment is applied,
is free from grease, paint, contamination and scale and is not coated, so that the teeth can
make good contact with the surface of the load.
Check the clamping jaws for wear and defects. They must have clean profiles.
Check the complete load lifting attachment for damage, cracks or deformations.
The load lifting attachment must open and close easily and freely.
Check the spring. When the lever is in the "Close" position, the spring must have a noticeable
spring pressure force when the suspension eye is depressed.
U O T
SAGE F HE
The load lifting attachment is fitted with a safety latch. When the operating lever is latched in
the "Open" position, the clamping jaw is raised and the mouth of the clamp is freely
accessible. In this position, push the load lifting attachment onto the load until the load to be
transported has fully entered the mouth of the clamp.
By switching the lever into the "Close" position, the clamping jaw is released. The clamping
jaw is firmly pressed against the load owing to spring pressure force. This ensures that the
applied load lifting attachment remains clamped to the load precisely as a result of the spring
force also without any pulling force. The load can now be lifted and transported.
At the end of the transport process, the suspension (e.g. hook, shackle, etc.) must be lowered
until the load lifting attachment is completely load-free and/or the suspension eye can be
moved freely. The lever can now be switched to the "Open" position again and the load lifting
attachment can be removed from the load.
Auf
open
ouverte
NOTE: The latching lever must be moved with care. Lashing of the lever may cause damage
to the toothing of the clamping jaws.
I / S
NSPECTION ERVICE
According to national and international accident prevention and safety regulations hoisting
equipment must be inspected:
• in accordance with the risk assessment of the operating company,
• prior to initial operation,
• before the unit is put into service again following a shut down
• after substantial changes,
• however, at least once per year, by a competent person.
Attention: Actual operating conditions (e.g. operation in galvanizing facilities) can
dictate shorter inspection intervals.
S
EFORE TARTING
L L A
OAD IFTING
©
2016 Columbus McKinnon Industrial Products GmbH
W
ORK
TTACHMENT
14
Zu
close
fermée