Installation Steps - MAHLE 480808011 Instrucciones De Montaje

Installation guide
Installation guide
1. Checking the electrical system:
Please check the following points before
deciding to replace the electric motor:
Is the power supply/battery charged and
■
in good condition?
Are the power supply cables/battery leads
■
correctly connected and not damaged?
Are all electrical connections tightly fitted
■
and free of corrosion?
Is the wire harness in proper working order
■
and not damaged?
2. Disconnecting the vehicle
battery—warning!
Disconnecting the vehicle battery may
■
result in the loss of codes in certain vehicle
systems. In this case the systems must be
reprogrammed or the codes re-entered.
Before disconnecting the battery, follow
■
the vehicle manufacturer's recommended
guidelines.

3. Installation steps:

3.1 Make sure that all power-transmitting compo-
nents and connections (electric, pneumatic,
and hydraulic) are shut o according to the
vehicle manufacturer's instructions and can-
not readily be switched back on. Remove
main fuse for the machine or system if possi-
ble. Disconnect the negative battery lead to
prevent an earth fault.
3.2 Remove the electrical connecting cables
from the currently installed electric motor.
Carefully mark the connecting cables accord-
ing to the associated output terminals on the
electric motor.
3.3 The electric motor can be used as a pump or
traction motor, depending on the application.
In either case, undo the fixing bolts and
remove the electric motor from the pump or
transmission. Follow the machine or system
manufacturer's instructions.
© MAHLE 2017 / 2018 | 7