Epson SureColor F6070 Manual De Instrucciones página 2

When the message
Chip unit expended
be refilled and the chip unit needs to be replaced soon. Obtain an ink pack of the appropriate color as soon
as possible.
Color Part number
Black T741100
Cyan T741200
Magenta T741300
Yellow T741400
You will be unable to print if a chip unit needs to be replaced. If the
displayed during a print job, you can replace the chip unit and refill the ink while printing continues. You
can use the same procedure to replace chip units for all colors.
Note: This printer has a remaining ink warning system. This system does not directly detect the amount of ink
remaining in the ink tank. Instead, the amount of ink remaining is estimated based on the ink usage conditions
and displayed as a message. The accuracy of this system depends on consistent and proper ink refills.
If the procedure for replacement and ink refilling below is not followed correctly, the remaining ink warning
system may not function properly. To prevent this, replace the chip unit and refill the ink as soon as possible once
the remaining ink level falls below 2.8 in. (70 mm) from the base of the ink tank.
Caution:
•
Store ink packs in a location out of reach of children.
•
Wear protective eyewear and gloves when refilling ink.
•
Be sure to read the Material Safety Data Sheet (MSDS) before using ink packs. You can download it from
your local Epson website.
•
Should ink contact your skin or enter your eyes or mouth, immediately take the following actions:
•
If fluid contacts your skin, immediately wash it off using large volumes of soapy water. Consult a
physician if the skin appears irritated or is discolored.
•
If fluid enters your eyes, rinse immediately with water. Failure to observe this precaution could result in
bloodshot eyes or mild inflammation. If problems persist, consult with a physician.
•
If swallowed, induce vomiting immediately and consult with a physician as soon as possible.
Note:
•
Gently cut or tear off the ink pack spout seal.
•
If you cut the ink pack spout seal too quickly, ink may splatter.
•
Do not squeeze open ink packs. Ink may spill.
Replacing the Ink and Chip Unit |
is displayed on the control panel, this means that the ink needs to
message is
Chip unit expended
1