Mega Construx Pokemon DYF10 Manual De Instrucciones página 4

SETTING UP THE CASE
1. Insert iPad into iPad holder, and press down
until it clicks into place. Make sure the camera
and microphone match up to the openings on
the iPad holder.
2. If you have a stylus or digital pencil, slide it into
the holder on the side of the case.
ESTABLISHING THE CONNECTION
To pair your keyboard case with your iPad:
1. Switch on the power button. If the LED status
light is red, charge the keyboard.
2. On your iPad, make sure Bluetooth
– Select Settings > Bluetooth > On.
– Select "iPad" from the Devices menu.
3. Press the Bluetooth connect button on the keyboard
®
for 2 seconds until the status light blinks.
The keyboard is discoverable for 3 minutes.
4. If your iPad requests a PIN, enter it using the keyboard
(not on the iPad), then press ENTER.
5. When a successful connection is made, the status
light stays on for a short time, then turns o .
FOUR VERSATILE
MODES
1. Typing mode
Pull out the stand
on the back of the iPad
holder to the desired angle.
Attach the keyboard,
and place the iPad case
on a at surface to start
typing.
3. Studio mode
Detach the keyboard.
Pull out the stand on the
back of the iPad holder until
the iPad is in a comfortable
drawing position.
English
is on.
®
20 70°
ON
2. Viewing mode
Detach the keyboard.
Pull out the stand on
the back of the iPad holder
to the desired angle.
4. Reading mode
Detach the keyboard.
Close the stand on
the back of the iPad holder,
and hold in portrait
orientation for the optimum
reading position.
2s