BGS technic 3287 Manual De Instrucciones página 7

APPLICATION
Note: Take the time to carefully select a work area.
Let the tool work independently without exerting extreme pressure! Excessive pressure reduces the
speed of the cutting disc and thus the cutting performance. In addition, the engine is unnecessarily
heavily loaded. Start the tool in front of the workpiece, then place it evenly on the workpiece and
move it in the desired direction to make the cut. After the cut, detach the tool from the workpiece and
then stop the motor.
By turning the adjusting wheel (1),
the desired speed can be read in four steps on
the marking (2).
CHANGING CUTTING DISC
CAUTION:
Disconnected air tool from air supply before replacing the cutting disc or other maintenance work.
Fig. 1
1. Turn the cutting disc by hand until the shaft lock is visible and the Counter key
can be attached (Fig. 1).
2. Loosen and remove the locking screw with the internal hexagon (Fig. 2)
3. Replace the old cutting disc with a new one.
Caution: Observe the information on the cutting disc.
Suitable for type 41 cutting discs.
4. After changing, the locking screw with hexagon socket and counter wrench tighten (Fig. 3).
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Fig. 2
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
1
2
Fig. 3
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed