Lamp Adjustment; Overhead Rigging - Futurelight PCC-500 Manual Del Usuario

Lamp adjustment

by turning the screws "A, B, C" counterclockwise ¼-turn at a time the light is bright and evenly distributed.

Overhead rigging

The installation of the device has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
When rigging, derigging or servicing the device staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
The device should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the device. If you lack these qualifications, do not attempt the installation yourself,
but instead use a professional structural rigger. Improper installation can result in bodily injury and or
damage to property.
The device has to be installed out of the reach of people.
If the device shall be lowered from the ceiling or high joists, professional trussing systems have to be used.
The device must never be fixed swinging freely in the room.
Caution: Devices in hanging installations may cause severe injuries when crashing down! If you have
doubts concerning the safety of a possible installation, do NOT install the device!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the device's
weight.
The lampholder is aligned at the factory. Due to differences between
lamps, fine adjustment may improve light performance.
Strike the lamp, open the shutter, set the dimmer intensity onto 100 %
and direct the light towards a flat surface (wall). Center the hot-spot (the
brightest part of the beam) using the 3 adjustment screws "A, B, C". Turn
one screw at a time to drag the hot-spot diagonally across the projected
image. If you cannot detect a hot-spot, adjust the lamp until the light is
even.
To reduce a hot-spot, pull the lamp in by turning all three screws "A, B,
C" clockwise ¼-turn at a time until the light is evenly distributed.
If the light is brighter around the edge than it is in the center, or if light
output is low, the lamp is too far back in the reflector. "Push" the lamp out
32/87 00026543.DOC, Versiom 1.6